Ambient Temperature Range (20–25°C, Standard Operating Conditions) – Basic Maintenance
Maintain Environmental Stability: Keep ambient humidity between 40% and 60%; avoid significant fluctuations in temperature and humidity.
Routine Inspections:Inspect surface conditions every three months; remove loose dust and minor stains, and verify the absence of rust or cracking.
Proper Storage: Separate adjacent ferrite components with magnetically insulating materials to prevent unnecessary magnetic interference.
High-Temperature Range (60°C to Rated Maximum) – Specialized Maintenance
Strict Temperature Control:Limit operating temperatures to below 80°C for standard permanent magnet ferrites; keep high-temperature models (e.g., Y30BH) below 250°C and plastic-bonded ferrites below 120°C. Avoid prolonged operation at the upper temperature limit.
Optimize Heat Dissipation and Structure: Design independent cooling systems for the associated equipment to prevent heat accumulation caused by overload; allow for thermal expansion clearances during installation and use non-magnetic spacers to compensate for deformation and prevent structural loosening.
Enhanced Surface Protection:In environments combining high temperature and high humidity, apply an epoxy resin coating to seal out moisture and prevent oxidation or rusting.
Frequent Inspections:Measure holding force at critical points monthly and record magnetic data; investigate operating conditions promptly if degradation exceeds 10%.
